全回转起重船多系统耦合运动响应仿真分析

根据运动学基本原理,计入船-吊物、船-锚链耦合影响以及起重船自身受到的外环境载荷,建立船舶多系统运动模型。利用MATLAB/Simulink软件进行仿真,对多系统耦合作用下的船舶运动进行数值分析。分别在不同的遭遇浪向角和不同的吊臂回转角下,对船舶在各自由度上的位移进行比较,得到其对船舶运动参数的影响规律。结果表明:起重船运动过程中因计入多系统耦合影响,自身运动也表现出更为符合实际的运动特性,为准确预报全回转起重船多系统的运动响应提供了更为科学的理论依据。     

可变截面涡轮增压瞬态性能仿真研究

为研究可变截面涡轮喷嘴开度对发动机的性能影响,建立GT-power和MATLB/Simulink联合仿真模型。采用GT-power软件建立的TBD234V12可变截面涡轮增压柴油机仿真模型研究发动机稳态性能,联合MATLB/Simulink软件建立的可变截面涡轮增压柴油机控制模型,对发动机瞬态性能进行仿真计算。结果表明:在发动机瞬态工况下,可变截面涡轮增压系统可以明显改善常规增压柴油机的动力性、经济性和动态响应特性,并且有效降低增压柴油机的时滞性,涡轮迟滞时间的降幅约为30%。     

带卸荷板的方块码头墙身位移对墙后土压力的影响

土压力与挡土墙体的位移密切相关,现行规范中采用主动土压力理论计算带卸荷板的方块码头墙后土压力是不完全准确的。根据此类码头结构特点,对地基条件好、基床厚度薄的方块码头墙身位移特性进行论述,对规范方法提出修正意见。依托于某工程实例,采用数值分析方法对码头墙身位移和墙后土压力进行模拟,并与规范公式计算结果进行对比,得出墙底处修正系数可取1.84,卸荷板处可取1.34,可为类似特点的工程土压力计算提供参考。     

小郭巨渔港工程防波堤平面布置方案

波浪是渔港建设中最重要的水动力因素,由于外海风浪作用强烈,影响港内渔船泊稳,需修建防波堤挡潮抗浪。从波浪角度研究防波堤平面布置,首先分析了舟山市六横岛小郭巨渔港工程的建设条件,确定防浪掩护控制标准,并提出防波堤直线形、折线形布置的8个平面布置方案。以满足渔船有效泊稳面积为准,采用MIKE21 BW模块计算在50 a一遇波浪与水位组合条件下堤后波高分布及防浪掩护效果,对8个方案进行研究,基于其中相对较优方案,进行了2个方案的优化。最终确定某渔港防波堤平面布置最优方案为:防波堤总长350 m、折堤夹角132°、直线段长122 m、折线段长228 m。     

钢-铝石墨半固态铸轧复合的数值模拟

铸轧区的温度分布直接影响着铸轧过程的稳定性和复合板材的质量.针对实验室复合板半固态铸轧试验的特点建立了数学模型,采用有限元法对钢-铝石墨半固态铸轧复合过程的热流耦合问题进行了数值模拟计算,分析了不同浇注温度和铸轧速度下熔池内温度场变化的情况.模拟结果表明,当浇注温度为620℃,铸轧速度在0.6～0.8 m/min的范围内可保证铸轧稳定进行,此结论与试验数据相吻合.该模型可以有效预测凝固前沿位置,为半固态铸轧复合工艺的进一步研究和钢-铝石墨复合板的数字化生产提供了依据.     

Ecologically based hybrid life cycle analysis of continuously reinforced concrete and hot-mix asphalt pavements

An ecologically-based hybrid life cycle assessment model is used to evaluate the resource consumption and atmospheric emissions of continuously reinforced concrete and a hot-mix asphalt pavements. The cumulative mass and ecological resource consumption values are lower for continuously reinforced concrete, but the median values of cumulative energy and industrial energy consumption were lower for hot-mix asphalt. In addition, the use of reclaimed asphalt pavement results in a higher sensitivity for the ecological resource consumption of hot-mix asphalt compared to that of fly ash when use on the natural capital utilization of continuously reinforced concrete pavement. The cumulative and industrial exergy consumption values are significantly reduced with increases in reclaimed asphalt pavement and fly ash, and the use of low fuel transportation modes.     

模拟计算法在重型车辆燃油经济性标准中的应用研究

随着节能减排压力的日益严重,世界各国均开始制定重型车辆的燃油经济性标准。在对重型车燃油经济性的测量方面,模拟计算法由于操作简单、可重复性好、成本低的优点越来越受到行业的重视,在日本、中国和美国的标准中都得到了应用。本文在分析模拟计算法测量车辆燃油经济性的原理基础上,对比研究了日本、中国和美国标准中模拟计算法的应用情况,分析了各国在模拟计算法关键环节上策略的异同。     

基于VB的测控装备模拟训练系统设计及实现

系统采用计算机仿真技术、系统仿真技术、网络技术、串口通信技术，介绍了该系统特点、组成和关键技术，并针对关键技术问题作了深入细致的探讨，给出了解决该问题的途径。     

The impacts of changing flight demands and throughput performance on airport delays through the Great Recession

Several significant events between 2007 and 2009 impacted flight demands and the abilities of the three major New York area airports to handle demand. This paper assesses the results of applying a probabilistic simulation method – which isolates the individual contributions of changes in flight demand and changes in airport throughput performance to changes in flight delays – to diagnose how these different events may have caused operational changes at these airports, and in turn, how the results may be used to inform policies for appropriate countermeasures. The analysis revealed two key observations. Firstly, certain patterns in throughput performance shifts caused the most significant delays, and were more likely to have been caused by controller staffing issues rather than caps. Secondly, relatively constant average delays from one year to the next may result from significant demand drops accompanied by large throughput performance degradations at an airport. This suggests that not only operational limitations on capacity encourage airlines to reduce schedules, but that changed demands can also impact throughput performance. Overall, the analysis indicates that caps may not have provided their fully intended delay benefits. Although they successfully reduced overall flight demands at LGA and JFK, they also directly limited throughput performance at critical times, in turn limiting delay benefits. In addition, demands at the busiest times of the day appear to be relatively inelastic to these operational limitations, insofar as demand profiles at EWR and JFK remained “peaky” in 2008 and 2009. Also, the recession was largely responsible for reducing demands at the airports in 2009, but the delay benefits of this were dampened by a corresponding throughput performance degradation. Based on the above observations, a more direct demand management policy combined with policies that focus on maintaining high staffing capabilities at critical times of the day may be considered, to reduce the likelihood of major queue formation on days that do experience sustained demands. The results also suggest that a more flexible caps system, particularly during times of heavy queues, could be explored. Although airport practitioners have keen understandings of how their airports operate, without the support of quantitative analysis tools, it can be more difficult to argue the need for appropriate countermeasures. An analysis such as the one presented here can provide the detailed quantitative substantiation required to build cases for these targeted policy directives and infrastructure investments.     

Influence of priority taking and abstaining at single-lane roundabouts using cellular automata

Existing roundabout simulation models fail to consider all types of driver behavior which compromises their accuracy and ability to accurately evaluate roundabout performance. Further, these non-compliant driver behaviors, including priority taking and priority abstaining, are inconsistent with existing traffic flow theories. In this paper, a new cellular automata model, C.A.Rsim, is developed and calibrated with field data from five single-lane roundabouts in four northeastern states. Model results indicate that approximately 20% of the individuals in the driver population are inclined to priority taking and approximately 20% are inclined to priority abstaining behavior, though the observed levels of these types of behavior are naturally lower and vary with traffic volume. The model results also corroborate other research indicating that current models can overestimate capacity at higher circulating volumes, possibly a result of the jamming effect produced by priority taking behavior. The reduction in priority abstaining behavior, which is observed at older roundabouts, significantly reduces delay and queue length in certain traffic volumes. C.A.Rsim is also more parsimonious than many existing microsimulation models. These results provide insight on how variations in conflicting flow (i.e., traffic volume and turning movement balance) impact the amount of observed non-compliant behavior.